[Elecraft] Quick KAT3 question...

[Shane DeSeranno]

>From the manual:
"If you do have a KAT3 installed, you can connect antennas to both ANT1 and 
ANT2; tap ANT to select. Holding ATU selects AUTO (autotune enabled) or 
BYPASS mode. In AUTO mode (ATU icon on), the antenna can be matched for best 
SWR by tapping ATU TUNE . Up to 30 ATU settings are saved for both antennas 
on every band."

That said, if I remember correctly, it's per antenna.  So if I set to BYPASS 
on ANT1, then switch to ANT2 and use the ATU, then switch back to ANT1, it's 
still in BYPASS. (I'd have to test to be 100% sure...)

-----Original Message----- 
From: Ross Primrose N4RP
Sent: Monday, November 14, 2011 12:33 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Quick KAT3 question...

With the KAT3, is the AUTO/BYPASS selection specific to ANT1/ANT2, or
does it apply the same setting to both ANT1 & ANT2?

73, Ross N4RP

-- 
FCC Section 97.313(a) “At all times, an amateur station must use the minimum 
transmitter power necessary to carry out the desired communications.”

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html