[Elecraft] k3 drive levels w/ KPA500

[W0MU Mike Fatchett]

Dick,

When the KPA500 is hooked up and in operate mode you can set each bands 
output.  When the amp is in standby mode then you can set the output to 
a different level.  This can be done per band if you set the PWR Set to 
per band instead of normal.

The K3 should tell you that it sees the KPA500.

Mike W0MU

J6M CQ WW DX CW Contest 2011
J6/W0MU November 21 - December 1 2011
W0MU-1 CC Cluster w0mu.net


On 11/12/2011 9:27 PM, Dick Frey wrote:
> How do I teach my K3 to go back to 100W when the KPA500 is off?
> Yes, the control cable is connected.
> 73, Dick
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html