[Elecraft] Help with K3 and Signalink USB

W0MU Mike Fatchett w0mu at w0mu.com
Thu Nov 3 23:01:48 EDT 2011


You have vox turned on?

Mike W0MU

J6M CQ WW DX CW Contest 2011
J6/W0MU November 21 - December 1 2011
W0MU-1 CC Cluster w0mu.net


On 11/3/2011 8:46 PM, Doug Shields wrote:
> Hello everyone,
>
>       I am sure there is a simple and thoroughly obvious answer to this but I
> haven't found it.  I have a K3 connected to a Signalink USB interface.  I am
> using the specific K3 cable that plugs in to the speaker and mic jacks on
> the K3.  I believe I have the internal jumpers on the Signalink set
> properly.  I have adjusted the sound card levels as recommended.
>
>     I can receive everything and decode signals just fine using Ham Radio
> Deluxe.  I just can't transmit any digital modes.  I have tried many
> combinations of settings with no luck.  The K3 goes into transmit but I get
> no indication of RF output.  It works fine on CW and SSB.
>
>      What am I missing?  Thanks in advance.
>
>
>
> Doug  W4DAS
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html


More information about the Elecraft mailing list