[Elecraft] K3 and MT63: XMIT Non-Copy

[Dan Sherwood]

I am trying to get my K3 to properly transmit in the MT63 digital mode, (1K,
max interleave), on a USAF MARS net.  Frequency just above 4 MHZ.  The KBPF3
module is installed.  I was running MIXW2.2, using the same installation and
settings that used to run perfectly on my TS-940S.  Our net is standardized
so everyone runs USB with the MT63 1K channel centered exactly 1 KHZ above
dial frequency.  I use the line input/output on the K3.  In USB mode I set
computer sound card output in s/w so that with power out set to 100W, and
line-in level at 10, the rig produces 50W and absolutely no ALC.
Compression was backed down to zero.  Using TX TEST and headphones, the
transmit audio sounds clean and distortion free.  Transmit EQ settings are
factory default.

Comments from net members are the audio sounds clean, and well centered on
frequency, (+ 3HZ within tolerance).  With live transmit, monitoring the
signal has no evidence of distortion.  The problem is the print is
double-spaced, with long strings of blanks, and all characters are lower
case.  Also much garble not evident on the TS-940S.  I realize the guys
recommend using DATA mode, but this net mixed voice and data ­ kind of tough
to be switching back and forth.

My copy on receive is as good as ever, just transmit.  I¹m thinking there¹s
some kind of DSP issue going on here, even though compression is at 0.

Any ideas?

Thanks

Dan Sherwood
AFA9LV / WA6PZK