[Elecraft] RF-Gain & S-Meter (again)

[Ron D'Eau Claire]

Those who have a P3 already have that antenna input signal strength reading,
in dBm or S-units right on the display - independent of gain controls, attn,
preamp, etc. 

Ron AC7AC


-----Original Message-----
I fully agree with Guy.

I wish the S meter would be changed to indicate true S level even with
RF gain turned down (as is usual if you're operating the RX
correctly).
What is the point of sticking with the 'OLD WAY' just because it's
always been that way.
This is an Elecraft K3 after all.

Elecraft, If it's really possible please do consider this change.

73, Deni
F5VJC

On 29 May 2011 21:33, Guy Olinger K2AV <olinger at bellsouth.net> wrote:
> Exactly, which is what most people expect, without knowing that they
> expect it, since 99% of ham receivers have done that since AGC first
> showed up.
>
> This behavior is CODED INTO the K3 firmware algorithm for the S-meter
> presentation.  It is not mandated by the way hardware is wired.  It is
> a choice made by the coder of K3 firmware, not the designer of circuit
> board traces.  The firmware COULD be coded to always show the signal
> level at the antenna input regardless of RF gain setting, which is
> what I would prefer.  This could be turned on when CONFIG:SMTR MD is
> set to ABS.
>
> 73, Guy.