[Elecraft] K3 CAT and SPE Expert 1K-FA

[Kjeld Holm]

DR OM

 

Tnx a lot. It was 38400. Changed it to 9600. Now all ok.

 

Best regards

Kjeld

 

 

-----Original Message-----
From: Ruben Navarro Huedo [mailto:runahue at gmail.com] 
Sent: 16. maj 2011 19:29
To: Kjeld Holm
Subject: Re: [Elecraft] K3 CAT and SPE Expert 1K-FA

 

Hello my friend.

I have the same setup.

How is your k3 serial speed in the menu?

 

73 EA5BZ

 

El 16/05/2011 15:03, Kjeld Holm escribió:

> Dear All,

> 

> I am confused after having tried almost anything to get my PC to 

> control both K3 and the Expert. I can controle K3 from HRD via COM1 

> with no problems.

> 

> My latest try to control the Expert was to have the factory make a 

> cable to me with DB-9 female from the computer and a DB-9 male going 

> to the K3 and a

> DB-15 male going to the Expert. So the cables should be all right from 

> the factory.

> 

> My Expert is set to CAT = Kenwood and BAUD RATE 9600.

> 

> My COM1 is set to Bits per second = 9600, Data bits = 8, Parity = 

> None, Stop bits = 1 and Flow control = None.

> For flow control I have tried also Hardware and Xon/Xoff

> 

> Result: K3 is following HRD fine. The Expert is doing nothing.

> 

> What am I doing wrong? (Now that the cable must be OK as it is made by 

> the Italian factory).

> 

> Vy 73 de

> OZ1CCM Kel

> 

> ______________________________________________________________

> Elecraft mailing list

> Home:  <http://mailman.qth.net/mailman/listinfo/elecraft>
http://mailman.qth.net/mailman/listinfo/elecraft

> Help:  <http://mailman.qth.net/mmfaq.htm> http://mailman.qth.net/mmfaq.htm

> Post:  <mailto:Elecraft at mailman.qth.net> mailto:Elecraft at mailman.qth.net

> 

> This list hosted by:  <http://www.qsl.net> http://www.qsl.net Please help
support this email 

> list:  <http://www.qsl.net/donate.html> http://www.qsl.net/donate.html

 

--

Rubén Navarro Huedo - EA5BZ

 <http://www.palotes.com> http://www.palotes.com