[Elecraft] Need Confirmation that my RX is operating correctly

[Don Wilhelm]

  Bob,

Listening with an antenna connected is not going to give you a clear 
picture of the receiver sensitivity.  It is hearing the ambient "band 
noise" which will vary from band to band, location to location, and with 
the time of day.

To determine sensitivity, you must disconnect the antenna - then turn up 
the gain, and you will hear the receiver "noise floor" - you still do 
not have an indication of receiver sensitivity, for that you must have a 
calibrated signal source for each band - something such as the Elecraft XG3.

73,
Don W3FPR

On 5/14/2011 6:18 PM, AB5N wrote:
> Hi guys-
>
> Well, this is just a call to other KX-1 operators to ask this question:
>
> When you cycle through the bands, are the noise floor (hiss) levels
> un-equal?
>
> My general sensitivity and hiss levels go as follow from most noise to
> least:
>
> 40 meters
> 20 meters
> 30 meters
> 80 meters
>
> 30 and 80 are obviously lower sensitivity than 20 and 40 in my RX. They are
> usable, but lower.
>
> This is say with a 25 foot wire attached... not a resonant antenna.
>
> What say?
>