[Elecraft] KPA-500 "Output for Input" schedule?

[Peter Wollan]

Perhaps that Mirage amp is intended for FM?  Not all amps need to be linear.

     Peter W0LLN


On Wed, May 11, 2011 at 2:02 PM, Wes Stewart <n7ws at yahoo.com> wrote:
> Then by definition, they aren't linear.
>
> A graph of output power vs. input power should be a straight line.  It it isn't then it's non-linear.  The practical question is how much non-linearity is acceptable.
>
> --- On Wed, 5/11/11, Julian, G4ILO <julian.g4ilo at gmail.com> wrote:
>
>>
>> If it does that then it will be the first linear amplifier
>> I have ever seen
>> that actually keeps that relationship across the whole of
>> its range.
>>
>> Most solid state amplifiers exhibit noticeable compression
>> as you increase
>> the input power, so you get a lot more than half the rated
>> power out for
>> half the specified drive power.
>>
>> Take a look at the figures for this Mirage amp (selected at
>> random as being
>> the first spec sheet I could find that proved the point.)
>> It is only truly
>> linear up to half its rated output. 10W in gives the rated
>> 160W output, but
>> 5W gives you 150W 2.5W would give you somewhere around
>> 120W. The VHF amp I
>> have here has a similar characteristic. Although it is
>> designed to be driven
>> with 5W input I am actually driving it with the K3/K144XV
>> with less than
>> half that power and still get virtually full output.
>>
>> So I think the OP actually asked a very reasonable
>> question.
>>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>