[Elecraft] P3 Strange Display Behavior on BSET

[Stan Gibbs]

I'm running P3 firmware 1.05.

If I have my SubRX enabled and the two receivers tuned to two different
signals, my P3 cursors are displayed exactly as expected.  If I then hit
BSET, the P3's VFO A cursor and display (including the displayed VFO
frequency) shift to the VFO B frequency, despite the fact that the audio for
both RXs does not change, indicating no change in the VFO A in reality. 
This also results in an incorrect display for the VFO B cursor because it is
displayed as though it were tuned to the VFO A frequency.  Tuning the VFO B
is no longer synchronized to the P3 display.

Turning off BSET returns the P3 display to the correct state.

Has anyone else seen this?


-----
73, Stan - KR7C
--
View this message in context: http://elecraft.365791.n2.nabble.com/P3-Strange-Display-Behavior-on-BSET-tp6346122p6346122.html
Sent from the Elecraft mailing list archive at Nabble.com.