[Elecraft] [K3] Programming - "ER" commands?

[Pierfrancesco Caci]

If possible, a sanitized command usable by anyone to read/write the
memories would be a nice addition to the programming interface. 

Pf




>>>>> "Wayne" == Wayne Burdick <n6kr at elecraft.com> writes:


    Wayne> Mike, This is one of several commands used only for factory
    Wayne> test, configuration, etc. To avoid unwanted side effects, we
    Wayne> recommend that third-party applications use only published
    Wayne> commands. I can give you a hand with these.


    Wayne> 73, Wayne N6KR


    Wayne> On May 7, 2011, at 5:28 PM, Mike Markowski wrote:

> Can anyone give the syntax of the K3's "ER" commands?  For instance,
    >> "ER0E804032;" apparently reads k3 memory location 10, but at
    >> first glance I don't understand the format of the command or its
    >> response.
    >> 
    >> The ER commands seem to be a much better way of interacting with
    >> the K3 for certain things than those published in the
    >> Programmer's Manual.
    >> 
    >> Thanks!  Mike ab3ap
    >> ______________________________________________________________
    >> Elecraft mailing list Home:
    >> http://mailman.qth.net/mailman/listinfo/elecraft Help:
    >> http://mailman.qth.net/mmfaq.htm Post:
    >> mailto:Elecraft at mailman.qth.net
    >> 
    >> This list hosted by: http://www.qsl.net Please help support this
    >> email list: http://www.qsl.net/donate.html

    Wayne> ______________________________________________________________
    Wayne> Elecraft mailing list Home:
    Wayne> http://mailman.qth.net/mailman/listinfo/elecraft Help:
    Wayne> http://mailman.qth.net/mmfaq.htm Post:
    Wayne> mailto:Elecraft at mailman.qth.net

    Wayne> This list hosted by: http://www.qsl.net Please help support
    Wayne> this email list: http://www.qsl.net/donate.html

-- 
Pierfrancesco Caci, ik5pvx