[Elecraft] 1 Hz setting?

[w5sxd]

Perhaps my XG3 is defective.

When running from the PC control program, I need to enter about a 10 Hz
change before the output frequency changes.  Is this normal or am I doing
something wrong?  The device is adverstised to have 1 Hz steps.

The calibration factor also needs to be changed by more the 1 step to get
the frequency to change.  

Also, the levels seem to be accurate at 160m but start to fall off in
accuracy as I go up to the higher bands.  Are they supposed to be into a 50
Ohm load?  Are they the level for the fundamental or total power output?

Thanks,

Richard W5SXD

--
View this message in context: http://elecraft.365791.n2.nabble.com/1-Hz-setting-tp6334687p6334687.html
Sent from the Elecraft mailing list archive at Nabble.com.