[Elecraft] [K3] multiple error messages on start-up

[John Shadle]

That was my first thought, Ron.

I had previously had my TUN PWR set to 25W, but when I looked at that
menu item it was set to 12W. I had not changed the setting.

The KPA100 was no offline in the config menu at all.

I reflashed the firmware and now it's all working, I think. The
LP-100A wattmeter is showing about 75W out with a 1.6 SWR into my
antenna (the K3 says I'm getting 100W out). That seems a little low to
me. Next I'll try a dummy load...

The investigation continues.

-john

On Wed, May 4, 2011 at 10:46 PM, Ron D'Eau Claire <ron at cobi.biz> wrote:
> Wow! I've not had those issues turn up on my K3, but suddenly not getting
> more than 12W out sounds like the KPA100 is off-line. Considering how
> "confused" the K3 acted previously, I'd check the CONFIG menu to ensure it
> still shows the KPA100 as "Installed".
>
> Ron AC7AC