[Elecraft] M1-M4

[Wes Stewart]

I use M1-M4 on each band as follows:

M1 = CW default frequency (usually the band edge) and BW = 400 Hz 

M2 = SSB default freq (i.e. 14.195) and BW = 2.8 KHz

M3 = PSK default freq, Mode = Data A and BW 2 KHz

M4 = RTTY default freq, Mode = AFSK A and BW = 250 HZ.

That's what I would like to do anyway.  The problem is, M3 and M4 do not remember the correct BW setting.  Regardless what is stored, if I for instance recall M4 (RTTY) after having just stored all of this in sequence, I will get the memorized 250 Hz BW.  If I then recall M3, I will have the *same* 250 Hz BW, not the expected 2 KHz BW previously stored in M3.

Apparently, my K3 isn't smart enough to know that Data A and AFSK A are different modes so recalling one or the other recalls the last used BW.

Am I missing something?