[Elecraft] [LP-PAN] K3 FW 4.31 problem

[Steve Ellington]

Well I just checked it again and now it's working ok. I guess the reboot from last night fixed it. Sorry if I caused any confusion! 

Steve
N4LQ
  ----- Original Message ----- 
  From: Larry Phipps 
  To: LP-PAN at yahoogroups.com 
  Cc: Steve Ellington ; Elecraft at mailman.qth.net ; Wayne Burdick - N6KR, Elecraft 
  Sent: Saturday, March 26, 2011 1:23 PM
  Subject: Re: [LP-PAN] K3 FW 4.31 problem


    
  Hi Steve. I tried 4.31 with the current version of LP-Bridge and I couldn't reproduce this with just LP-Bridge or with LP-Bridge and PowerSDR/IF v1.19.3.5. I did have a little trouble getting 4.31 to load, but after a couple tries it loaded OK. It is normal for PowerSDR to mute when XMIT is pressed or key/paddle is used, but in my case it releases quickly as it should. What polling rate are you using for LP-Bridge and what kind of serial port do you have? I have an FTDI USB to serial adapter on my laptop. The OS is W7 32-bit.

  73,
  Larry N8LP



  On 3/25/2011 6:26 PM, Steve Ellington wrote: 

    I recently loaded new firmware 4.31 and observed the following when used with PowerSDR-IF and LPPAN.
    PowerSDR enters MUTE status when K3 buttons RIT, XIT, XMIT, Menu are used. Also happens when K3 is keyed with key or paddle. PowerSDR-IF MUTE triggers and will not disengage automatically but will release when clicked with mouse.
    Has anyone else noticed?
    Steve
    N4LQ



  __._,_.___
  Reply to sender | Reply to group | Reply via web post | Start a New Topic 
  Messages in this topic (2) 
  Recent Activity: a.. New Members 4 a.. New Links 1 
  Visit Your Group 
  MARKETPLACE
  Stay on top of your group activity without leaving the page you're on - Get the Yahoo! Toolbar now.

   

------------------------------------------------------------------------------

  Get great advice about dogs and cats. Visit the Dog & Cat Answers Center.

    Switch to: Text-Only, Daily Digest . Unsubscribe . Terms of Use.
   
  __,_._,___