[Elecraft] PLL upgrade board on K2 7109

[Don Wilhelm]

  Ed,

Check the schematic.  You will find that one end of RB is connected to 
both RC and RD, and further connected to pins 2 and 3.

The troublesome one is usually RE which is close to one end of RC - 
those two points should not connect together.

73,
Don W3FPR

On 3/11/2011 8:57 PM, EMD wrote:
> I think I created a solder bridge between the 1/8W resistor RB and the 3rd
> pad under the resistor, on the PLL upgrade board.  I have tried to wick up
> the excess solder but I still cannot determine if this is okay or that the 2
> pads should be separate.
>
> 73,
> Ed KE7HGA
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/PLL-upgrade-board-on-K2-7109-tp6163532p6163532.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>