[Elecraft] T1 build...

[Don Wilhelm]

  Ross,

Who knows what the L and C values are that are in your T1 until you do a 
TUNE.  The incication of a low SWR when the T1 is in bypass indicates 
that there is residual reactance when in non-bypass.  Doing a TUNE 
should straighten things out.  The settings are remembered by band, so 
do a TUNE on each band.

73,
Don W3FPR

On 3/6/2011 8:22 PM, Ross Primrose N4RP wrote:
> OK, so I finished the build yesterday, and today, after I built another
> BNC-PL259 cable so I could hook it up, I did the performance tests.
> Everything seems OK, except the transmit power display tests.  The T1
> shows the correct power level, but the K3 indicates at>10:1 SWR during
> the power measurement.  Bypass mode works fine, if I put the T1 in
> bypass and hit the tune switch on the K3 the dummy load gives a 1:1 SWR,
> it's only a problem when trying to display power....
>
> Ideas?
>