[Elecraft] K3 Front Panel Headphone Jack Problem

[Gary K9GS]

Before I did anything too radical I'd try re-soldering the jack 
connections to the PCB.

On 3/4/2011 4:19 AM, Mark Cherry wrote:
> Hi all,
>
>
>
> I have been experiencing a problem with the front panel headphone jack.
> Regardless of the ¼” plug used, I must put side pressure to get both audio
> channels to function, and then the weight of the cord will cause the
> connection to be lost again.  I realize the jack most likely needs
> replacement and that is where my question comes in.
>
>
>
> Has anyone had this issue and/or replaced one of these?  I can purchase the
> part from Elecraft, but should I damage the DSP board, I’ll need to purchase
> a new one.  Also, if Elecraft attempts a repair, and they are not
> successful, again, I am on the hook for a new board, about $400.00.
>
>
>
> I would like to be able to use the front panel jack, I know there is one on
> the rear, but the convenience is not there.
>
>
>
> So, if anyone has any hints or experience on replacing this part, I would
> really like to hear from you.  I can’t imagine I am the only one having a
> problem as this jack has rarely been used, until my current need came up.
>
>
>
> Thanks to all in advance for your input.
>
>
>
> Mark – WT6P
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

-- 


73,

Gary K9GS

Check out K9NS on the web:  http://www.k9ns.com
Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com

************************************************