[Elecraft] K2/100 75 meters lost receive

[Don Wilhelm]

  Chuck,

The usual cause for "no receive on one band" is that the RX ANT has been 
selected for that band.  While on 80 meters, enter the menu and check to 
see if it is on or off.

73,
Don W3FPR

On 6/24/2011 1:03 AM, 2Cents wrote:
> Hello group,
>
> My K2/100 with KAT2 seems to have lost recieve on 75 meters only. It
> transmits fine there but upon releasing the mic it sounds like the coax has
> been cut.  This is in a mobile installation using a screwdriver antenna with
> a swr of less than 1.2:1.  It matters not whether the ATU is in line or
> bypassed--receive sensitivity is very low.  If I tune my antenna analyzer to
> the same frequency and hold it close to the radio it will pick that up and
> display an s-meter reading, so I know it's not stuck in transmit.
>
> All other bands work normally.
>
> Where do I start?
>