[Elecraft] K2 Serial Number 7174 Installation of P1 on RF Board on Wrong Side

Vic K2VCO vic at rakefet.com
Wed Jun 22 12:09:24 EDT 2011


You do not lack the skill needed, but you will need a new connector! You can get one from 
Elecraft.

Cut the old one off with your flush-cutting wire cutters. Just cut through the plastic. 
Then remove the pins one at a time. Clean the holes with solder wick. Install the new one. 
That's it.

On 6/22/2011 4:30 AM, Jerry Roe wrote:
> As the title suggests, I have installed P! on the RF board on the wrong side
> of the board. I am sure that I lack the skill and equipment to remove the
> connector now that I have made this serious error. What do I do now?

-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/


More information about the Elecraft mailing list