[Elecraft] [K3] AGC-OFF

[Dave Hachadorian]

There are two major problems with turning off the K3's AGC:

1.  There is very little dynamic headroom until the AF Limiter 
causes severe distortion on even a moderately loud signal, even 
if the AF Limiter setting is max.

2.  Never use the speaker amp with AGC turned off.  It takes just 
one dit from a loud signal to destroy the delicate speaker 
amplifier IC.  That will require a $110 factory repair, plus 
postage.


Dave Hachadorian, K6LL
Big Bear Lake, CA




-----Original Message----- 
From: Kevin Rock
Sent: Tuesday, June 21, 2011 10:12 AM
To: Elecraft
Subject: [Elecraft] [K3] AGC-OFF


I was having a hard time making out characters today during my 
daily sked
into the Southeast.  The QSB was a fast flutter and was chopping 
up the
letters badly.  I was running fast AGC and thought maybe slowing 
it down
may help.  It did - a little.  So I took the next logical step 
and turn
AGC off entirely.  The characters popped right out at me.  I just 
rode the
RF gain as the signal went through its slower QSB while the fast 
flutter
QSB did little to bother me.  AF gain was cranked to high as I 
normally
run it while RF gain was set to where the background QRN was 
minimized.
Turning off the AGC helped eliminate the fast flutter problems 
which were
causing me difficulties copying.

This is most likely old news to many of you but I have been 
running AF
gain at max and controlling volume with the RF (or IF) gain since 
1960
when I first started SWLing on my brother's Lafayette receiver.

I hope this helps at least one of you drag out a new one.
    73,
       Kevin.  KD5ONS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: 
http://www.qsl.net/donate.html