[Elecraft] P3 (fine tune mode)
Gary Gregory
garyvk4fd at gmail.com
Tue Jun 21 00:19:52 EDT 2011
I think this would be a very good feature to have. I do not like the way the
QSY Tap is used also. I can never end up where I need to be without going to
the main VFO etc.....
Hopefully the powers that be are listening....:-)
Gary
On 21 June 2011 13:11, Bob Cunnings <bob.cunnings at gmail.com> wrote:
> I suggested the same thing a while back...
>
> http://www.mail-archive.com/[email protected]/msg100958.html
>
> so it's nice to know I'm not alone!
>
> Bob NW8L
>
>
> >I’m new on the reflector as of today. I searched for this and didn’t see
> >anything that addresses my thought and I hope I’m not repeating something
> that
> >has already been covered somewhere. If so, please let me know.
>
> >To me it would be useful if the following capability were available to me:
>
> >When I move a marker with the P3 knob and then tap it to tune the K3
> frequency
> >to my selection, I almost never hit the exact carrier frequency in SSB.
> I
> >then have to move my hand over to the K3 VFO for fine tuning. It’s not a
> big
> >deal but over and over in a contest this might become time consuming.
>
> >If, after tapping the select knob on the P3 it would be useful to me if,
> for a
> >few seconds, the knob were to become a direct K3 fine frequency tune
> control.
> >I wouldn’t have to switch back and forth between the P3 & K3 all the time.
> If
> >the knob isn’t turned for a short time, say 5-seconds, it would revert to
> its
> >normal operation of moving the marker only.
>
> >Others’ thoughts on this would be welcome.
>
> >Thanks,
> >Bob, W7KWS
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
--
VK4FD - Motorhome Mobile
Elecraft Equipment
K3 #679, KPA-500 #018
Living the dream!!!
More information about the Elecraft
mailing list