[Elecraft] P3 beta, A/B operation

[Corin & Alan]

I sometimes use the A/B to switch between the CW and phone section of a band.  I like to set the P3 to FixMode and adjust the right edge to align with the band edge, say 14.000.0.  So if I set VFO A to 14.025 in CW mode and switch to VFO B at 14.240 also in CW mode I can switch back and forth and the edge shown on the P3 stays set to 14.000.0.  However, if VFO B is set to 14.250 in USB, when I switch back to VFO A the edge shown on the P3 changes to 14.001.5?  Huh?  Otherwise, I like to new cursor and improvements.

73s, Al, K6IV