[Elecraft] K3 with Kenwood MC-60

[Jeff KB2M]

Thanks Steve that did it. I don't need the mic up and down buttons so
disabling them in the K3 config was the answer.

73 Jeff kb2m
 


-----Original Message-----
From: Steve WU9B [mailto:wu9b at desertinet.com] 
Sent: Saturday, June 18, 2011 16:08 PM
To: Jeff KB2M
Subject: Re: [Elecraft] K3 with Kenwood MC-60

Try Config: MIC BTN OFF (as opposed to ON)
73, Steve WU9B

On Jun 18, 2011, at 12:39 PM, Jeff KB2M wrote:

>  I picked up a used MC-60 mic at Dayton. When I try to use it with my K3,
> as soon as I connect it via the 8-pin foster on the front  the frequency
> starts to scan like I'm holding down the up button on the mic. Thinking
that
> there was a problem with the mic I tested it with a Kenwood TS2000 and it
> works perfectly. You push the up button and it scans up, etc. Now what
> puzzles me is that I used to own another MC-60(that I sold) and it worked
> correctly with my same K3. I'm wondering what could be causing this before
I
> start to take everything apart. Anyone else run into this, does anyone
have
> any ideas?
> 
> 73 Jeff kb2m
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html