[Elecraft] K2 Front Panel assembly question

[Mike K8CN]

Hi Ron,

Check Figure 5-9 on page 27 of the rev. H manual - the spacers are used only
temporarily to set the height of the backlight assembly prior to soldering
its pins in place.  I suppose any other means you might devise to keep the
backlight 1/8 inch off the front panel board and parallel to it would be
acceptable (presuming you can extract the spacer after the backlight pins
are soldered :) ). Don, W3FPR may have a better suggestion.

73,
Mike, K8CN

--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-Front-Panel-assembly-question-tp6485680p6489056.html
Sent from the Elecraft mailing list archive at Nabble.com.