[Elecraft] [K3] K3EXREF K144REFLK and K144XV

[Bruce Beford]

I understand that when using the K3EXREF there is no need for this data.
But, what I was wondering is if this would be a method by which an end user
of the KTCXO3-1, (or Elecraft internally) could use this or a similar method
to compile this 1 degree increment data easily? It could be used when not
running with the external ref online, or could be included as test data from
Elecraft with a KTCXO3-1 purchase. 

I am also interested in the K144XV's PLL being corrected by the K3EXREF, and
hopefully, an automated correction instead of the 116MHz/118MHz manual
calculation and data entry now required when using the K144RFLCK.

73,
Bruce
N1RX



> There is no need to do any type of temperature correction if you're  
> using the K3EXREF. This option uses an external reference to send  
> corrections to the K3's MCU automatically so that it always knows the  
> actual frequency of the 49-MHz oscillator.

> What some are asking for is that the K144XV's PLL module also receive  
> the benefit of this correction when the K3EXREF is installed. That's a  
> small matter of programming on my part.

> 73, Wayne N6KR