[Elecraft] K3 and Ham Radio Deluxe

[Don Wilhelm]

Jorge,

Do you have N1MM running when you start HRD?

If so, COM8 is already in use by N1MM and HRD cannot use it because N1MM 
is using the port.
Close N1MM and try HRD alone.

If you want multiple applications to use the same port that is connected 
to the K3, you will have to use a software application that provides 
virtual ports.  LP-Bridge is a good example and supports the K3 very 
well (in fact the K3 is the only radio it virtualizes).  It is available 
from www.telepost.com.

73,
Don W3FPR

On 7/31/2011 5:43 PM, Jorge Diez - CX6VM wrote:
> Hello,
>
>
>
> I have the K3 connected to N1MM and working without problem. I have WKUSB to
> COM7 and RS232 to USB cable (that I bought at Elecraft when I bought the K3)
> connected to COM8 at 38400 bps
>
>
>
> Now I installed HRD, open it and selected Elecraft K3 in COM8 and 38400 and
> I have this error
>
>
>
> K3, COM8, 38400 denied access
>
> Make sure your radio is switched on and not in memory mode
>
> If you are using a homemade/non-standard cable you may need to select RTS
> and/or DTR
>
>
>
> Any idea what´s wrong?
>
>
>
> 73,
>
> Jorge
>
> CX6VM/CW5W
>
> K3 #4077
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>