[Elecraft] split pileup and listening was Pileups and KPA500/ST0R

[Cady, Fred]

Hi Don (et. al.)

I put a fair amount of explanation of split operation in "The Elecraft
K3: Design, Configuration and Operation." You can see some of it by
going to 
http://www.ke7x.com/home/guide-to-the-k3/chapter-3-1
and scrolling down to section 3.2.10.
Give it a try. It is very satisfying (at least to me) to figure out how
and where the dx is working and then to be able to jump in and work it.
I got the ST0 on 20m running barefoot with a dipole. (I do have the
advantage of the second receiver and a P3, though).
Good luck and 73,

Fred Cady, KE7X
fcady at ieee dot org 
www.ke7x.com

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net [mailto:elecraft-
> bounces at mailman.qth.net] On Behalf Of goldtr8 at charter.net
> Sent: Sunday, July 31, 2011 6:39 AM
> To: bob finger
> Cc: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] split pileup and listening was Pileups and
> KPA500/ST0R
> 
> Bob,
> 
> I have never understood this whole split operation setup much less
> figuring out how to listen to someone working split and doing what you
> stated below.
> 
> Would you please try and explain it to me.    Others have tried but
for
> some reason i just dont get it, or it wont sink in.
> 
> I was on the radio yesterday and saw many folks calling ST0R and
> figured
> that wont work so well.
> 
> Thanks
> 
> ~73
> Don
> KD8NNU
>