[Elecraft] KC9EHQ New KSB2 revision issues

[David Pratt]

I have overcome a similar problem in the past by strapping a needle to
my soldering iron bit.  By using an high iron temperature it is possible
to insert the needle slowly into the hole and causing excess solder to
melt.

73 de David G4DMP

In a recent message, Don Wilhelm <w3fpr at embarqmail.com> writes
>It is *possible* to drill out the holes (but certainly not
>recommended).  If that is done, it will be necessary to solder the lead
>on both the top and bottom of the board (because the thru-plating will
>be destroyed).
-- 
 + - - - - - - - - - - - - - - - - +
 | David M Pratt, Kippax, Leeds.   |
 | Website: http://www.g4dmp.co.uk |
 + - - - - - - - - - - - - - - - - +