[Elecraft] [k2] Poor USB audio after cal

[aj4tf]

I guess you know that it is NOT recommended to try and remove the flux from
the boards after construction... if you don't get every bit of it off after
you dissolve it with whatever solvent you're using, you'll end up with a
severely contaminated board and future problems with it.  If you have used
quality solder as recommended by Elecraft, there should be no reason to
apply extra flux during construction nor any reason that you would need to
clean the board after soldering.    

Just my $0.02

de AJ4TF

--
View this message in context: http://elecraft.365791.n2.nabble.com/k2-Poor-USB-audio-after-cal-tp6616641p6616993.html
Sent from the Elecraft mailing list archive at Nabble.com.