[Elecraft] XV-144 Receiver RF Amp Bias Adjustments

[Don Wilhelm]

David,

If you found zero volts at D3, then R12 is not fully soldered.  OTOH, if 
you found close to 12 volts, D3 is not doing its job.

Good luck on finding parts at RS if it is anything like the store in my 
area.

73,
Don W3FPR

On 7/23/2011 9:38 AM, KJ4YQK wrote:
> Hi Don,
>
>
>
>     Tnxs for the reply.  I broke a resister R14, lifting one end to read.  It
> check good before the lead broke off.  Head to Radio Shack to pick up a new
> one.  I did not get the 6.8 volt at the C4 D3 Junction.  I will retouch the
> solder joints with the iron to see if it comes back.  Will pick up an extra
> D3 while I am radio shack just in case.
>
>