[Elecraft] K3 PSK problem

[george fritkin]

"Sometimes" computers do things their own way.  Double check that your sound card selection has not changes.  Also make sure your data selection on the K3 is set properly
George, W6GF


--- On Fri, 7/15/11, Don Wilhelm <w3fpr at embarqmail.com> wrote:

From: Don Wilhelm <w3fpr at embarqmail.com>
Subject: Re: [Elecraft] K3 PSK problem
To: "N0OKS" <kachels at wi.rr.com>
Cc: 
Date: Friday, July 15, 2011, 3:44 PM

  Mark,

Can you transmit OK in SSB mode?
If so, the audio level is your problem.  You can check in TX TEST so you 
generate no RF.
Adjust the audio level from your soundcard (and/or the Line-in level on 
the K3) to produce 4 bars with the 5th one flickering on the ALC meter 
(that is the no-ALC level for the K3, ALC begins with the 5th bar.)
Once you have done that, adjust the K3 power with the power knob.
Do not try to operate the K3 as you may have done with other 
transceivers - that is adjusting the RF level with the audio drive.  Fo 
the K3, set the audio drive, and adjust the power with the power knob.  
You will get power creep if you use the audio to adjust the power.

If you have an interface device between the soundcard and the K3 
Line-in, make sure the interface is set for line level output - most 
default to mic level out which is much smaller than line level.

73,
Don W3FPR

On 7/14/2011 4:58 PM, N0OKS wrote:
> I have a K3 / 10 that I built last December. 800 CW QSOs and 9 recent PSK
> QSOs. Firmware is version 4.22
>
> I set up PSK according to the instructions on the Elecraft web site. Other
> than setting vox gain to 2, from 1, I had no problem getting on PSK. I did
> nine PSK QSOS and now this:
>
> Clicking on CQ in DigiPan gives me just one bar of power, power set for 12,
> and no ALC bars. This had worked fine before.
>
> Going to Tune, on the K3, gives me five power bars, tune set for five watts,
> and four ALC bars
>
> Going to Transmit, on the K3, gives me one power bar and no ALC bars.
>
> Any Suggestions?
>
> Mark, NØOKS
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/K3-PSK-problem-tp6584871p6584871.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html