[Elecraft] This is weird. K3

[Greg]

Sounds like the CONFIG KXV3 menu item got set to TEST.  This routes all the
RF to the xverter BNC outputs at low power.   See page 49 of the current
manual.  Restoring your configuration probably corrected it.

73
Greg
AB7R


On Sun, Feb 27, 2011 at 10:21 AM, Paul VanOveren <nf8j at wolphi.com> wrote:

> All of a sudden my K3 # 758 is acting weird.   It recognizes the ATU in
> that
> the little ATU is present on the display, but no signals are received in
> the
> radio, only a hiss.  If  I try to adjust the power setting  it will read
> from 0.10mw and - 10.0 db  to  1.5 mw and 1.8 db on the display, it stays
> there for only a second or two and then the display return s to normal.
>
> Altho the atu is showing on the display and I tap the tune button, the
> display changes to NO ATU and the normal clicking sounds is not there.
>
> When I hold the XMT button to perform the Tune function, the display
> changes
> to 1.8 db and 1.5 mw rather than the swr and power, it does change to the
> cw
> mode however.
> This all happened after I unhooked the rs232 cable from the back of the K3
> so I could plug in my Yamaha CM-500 headset, which I removed for a day.
> Just
> for grins I went to the K3 Utility and did the resore K3 configuration
> button. Presto, signals back, power control normal, ATU clicking again,
> Tune
> fuction reading swr and power...I am so glad, but can anyone tell me why
> removing the cable from the laptop to the K3 evidently corrupted something?
>
> Sincerly,
> NF8J
> Paul VanOveren
> 5911 Snow Ave.
> Alto, Mi
> 616-868-7149
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>