[Elecraft] K2 Control Board resistance checks

[Don Wilhelm]

  Ed,

The first two readings are very likely OK, you might re-check by 
reversing the leads or putting new batteries in your DMM.  The other 
possibility is that you are using auto-ranging, and the reading may be a 
bit different if you switch to the first fixed range greater than 90k

I don't know how you DMM indicates an infinite reading, but you can 
easily check - it will be the same reading as you get with nothing 
connected to the leads.

73
Don W3FPR

On 2/12/2011 1:19 PM, EMD wrote:
> I have some questions on the results of my check.
> U6 pin 29 should read between 70 and 90k, I'm reading 96k.
> U6 pin 30 should read between 70 and 90k, I'm reading 97k.
> U8 pin 15 and 16 should read>100k, I'm not getting a reading at all so I'm
> wondering if this is the way my DMM reads infinity.
>
> Are these readings in the ball park or do I have some trouble some where?
>
> 73, Ed
> KE7HGA