[Elecraft] Erratic transmit power -- ALC oscillating?

[n7zf]

This is a new build of a rev A K2 (installed rev B mods), rework eliminators,
no options installed, several other mods installed including the CW waveform
keying mod (VALC circuit).  Receiver is working well.

If I set the output power to 5 watts,  the usually K2 reports the power as
4.2 watts or 6.3 watts -- sometimes 5.1 watts.  I am seeing some unexpected
things in the ALC circuit on the control board and am wondering if the ALC
is causing the transmit power to fluctuate.

In both transmit (cw) and receive mode, on all bands, there is a 45 hertz
0.7 volt spike coming out of U10A (LMC660), causing Q8 to turn on for about
3.5 msecs every 22 msecs.  The B-E junction of Q8 is limiting the spike
voltage.  See photo of signal on pin 1 of U10 -- same as base of Q8.  Using
a 10x probe, so vertical scale is 200 mV per division, horizontal scale is 5
msec per division.

At the junction of R22 (82K) and R21 (270K) I am seeing a 1volt peak-to-peak
signal being fed back by C46 (.01).  Is this expected?  I see this 'ripple'
continue as a 150 mV peak at Test Point 2, and also on the output of the
Xmit Mixer U10-pin4 during transmit.  I have removed the control board and
verified all the correct components against the Rev. H schematic.  I have
traced all the connections in that circuit.  I have rechecked against the
keying mod instructions.  The CW key waveform modifications appear to be
working correctly but is the ALC circuit supposed to be oscillating?

The CW keying mod (rev A 2/3/2004) specifies C31 to be .01 uF.  The Rev
A-to-B upgrade (rev E 4/29/2003) specifies C31 to be .047 uF.  I assumed
that the CW keying mod was a more robust change and followed it (so C31 is
.01 uF).

Same problem running off a power supply or a battery.  I have installed new
power amp finals and new power amp bias transistors.  I have carefully
inspected T1-T4 in the final, including removing T3 and rewinding it.  I
have tested the low pass filters with a network analyzer and found no
problems.  I have measured and inspected the RF Output Detector circuit (and
have the 1% resistor at R68 which measures to be 225.0 ohms).

I am grasping at straws at this point and would appreciate troubleshooting
suggestions.
Bob N7ZF
http://elecraft.365791.n2.nabble.com/file/n6013475/control_board_ALC_spikes_on_U10-pin1_.jpg 
-- 
View this message in context: http://elecraft.365791.n2.nabble.com/Erratic-transmit-power-ALC-oscillating-tp6013475p6013475.html
Sent from the [K2] mailing list archive at Nabble.com.