[Elecraft] [Elecfaft K3] Power Cycle

[Matt Zilmer]

They are complete resets, occurring after MCU, DSP1, DSP2 loads.  Note
that the K3 goes through exactly the same LED test sequence and timing
is the same as a full reset.  The only difference between 'normal' and
loading resets is that during loading the resets occur during power
on.

matt W6NIA

On Mon, 07 Feb 2011 08:34:17 -0500, you wrote:

>Everyone, 
>Many times by both the K3 engineers and others it has been stated to recycle the K3 power after doing a firmware upgrade. I understand the logic behind this action and do perform a power reset after doing a firmware upgrade or reload.  My question is this. Every time a firmware upgrade is installed there are several apparent power resets that occur, even after the firmware install is finished. Am I correct in assuming these apparent power resets are not complete resets?
>
>Thanks and 73
>Dave KD1NA
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html