[Elecraft] K3 REV button problem

[J. Wolf]

   Yes, I've noted the proximity of the two buttons, but even being careful 
not to hold the split button inadvertently I've still had the problem. I 
like your suggestion about the lock button, though. Maybe Elecraft will take 
a look at the issue and provide some insight and a solution?
--Jeff, K6JW
***
You wrote:
Hi Jeff,

I experienced the same behavior. But after some investigation i found here 
it was a user error. Unfortunately the A-B (Split) button is just beside the 
REV Button. So when holding the wrong button because of my fat fingers the 
Split is gone .... and UP calls are generated ;-)

Suggestion to ELECRAFT: in LOCK mode also lock A-B (Split) button -

I normally run the pileup with locked VFO. If this would also lock the A-B 
(Split) button this problem cannot happen. Just turning off Split will need 
holding two buttons instead of one. But in pileup Split mode I do not need 
to go to the DX QRG. There are normally more than enough UP callers.

73 de Olaf - DK2LO