[Elecraft] K3 Firmware Reload Reminder

[Cady, Fred]

Also, remember to turn the K3 power off and then on after loading
firmware.

Fred Cady
fcady at ieee dot org  

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of K5WA
> Sent: Saturday, February 05, 2011 7:56 AM
> To: 'Elecraft reflector'
> Subject: [Elecraft] K3 Firmware Reload Reminder
> 
> I know this gets mentioned regularly but it sure worked for 
> me today.  I got
> a very strange behavior after loading FW 4.25.  My S meter 
> would jump to
> full scale whenever I reduced the bandwidth below 500 Hz and 
> the RX would go
> dead.  After a lot of head scratching and unplugging of 
> cables to eliminate
> issues, I reloaded 4.25 and everything just worked perfectly 
> again.  I guess
> the bits and bytes get crossways occasionally and a nice reload puts
> everything back in order.  I hope you think of this faster 
> than I did if you
> ever need a bit of help.
> 
> 73,
> Bob K5WA
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>