[Elecraft] K3: Erratic behavior of REV button

[Olaf Achterberg]

Hi Jeff,

I experienced the same behavior. But after some investigation i found here it was a user error. Unfortunately the A-B (Split) button is just beside the REV Button. So when holding the wrong button because of my fat fingers the Split is gone .... and UP calls are generated ;-)

Suggestion to ELECRAFT: in LOCK mode also lock A-B (Split) button -

I normally run the pileup with locked VFO. If this would also lock the A-B (Split) button this problem cannot happen. Just turning off Split will need holding two buttons instead of one. But in pileup Split mode I do not need to go to the DX QRG. There are normally more than enough UP callers.

73 de Olaf - DK2LO
-- 
NEU: FreePhone - kostenlos mobil telefonieren und surfen!			
Jetzt informieren: http://www.gmx.net/de/go/freephone