[Elecraft] control knobs Jumpy ( Not Lousy)

[n5ge at n5ge.com]

No problem with that here, but I think Joe is probably right.  

I used to use HRD, but it DID have a tendency to interfere with the operation of
the K3.  I believe Joe once said several problems are caused by excessive poling
from HRD.

73,
Tom
Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member

"If somebody has a bad heart, 
they can plug this jack in at 
night as they go to bed and it 
will monitor their heart 
throughout the night. And the 
next morning, when they wake up 
dead, there'll be a record."

--Mark S. Fowler, FCC Chairman,
  1981 - 1987


On Mon, 26 Dec 2011 11:41:23 +0100, Jens Petersen <ov1a at c.dk> wrote:

>On Sun, 25 Dec 2011 09:07:28 -0800 (PST), you wrote:
>
>>when adjusting the knob (power level) the value jumps up, 
>>down, slow, fast, all over the place.  Sent rig back for upgrade
>> ...came back and this is still a problem...anyone else have this?
>
>Same problem here.
>
>If I adjust power very slowly there is no problem, but when adjusting
>in normal speed the value is jumping.
>
>No problem with filters and mic gain.