[Elecraft] control knobs lously

[Jim Harris]

Hi,
I had a similar problem with setting power.  Sometimes it would take several turns to get the power set where I wanted it especially after the radio had been on for a while.  It took over six months to convince Elecraft there was a problem.  Finally, they send a new power encoder which I installed.  Works as it should now.  Be sure you are well versed in soldering before tackling it.  Your problem may could be something different.  Keep it in front of support is my best advice.
Take pride in the USA. 73

Jim, W0EM

Message: 1
Date: Sun, 25 Dec 2011 09:07:28 -0800 (PST)
From: ussv dharma <ussvdharma at yahoo.com>
Subject: [Elecraft] control knobs lously
To: "elecraft at mailman.qth.net" <elecraft at mailman.qth.net>
Message-ID:
    <1324832848.13945.YahooMailNeo at web120904.mail.ne1.yahoo.com>
Content-Type: text/plain; charset=iso-8859-1

when adjusting the knob (power level) the value jumps up, down, slow, fast, all over the place.? Sent rig back for upgrade ...came back and this is still a problem...anyone else have this?

Susan Meckley, Skipper W7KFI-mm? AFA9SM
???????????????????????? USSV DHARMA