[Elecraft] K1: noise blanker instructions theory

[Stephen Prior]

This is reposted, since I never saw it appear on the list, apologies if it's
a dupe.

AnywayŠŠŠŠ..


I'm just about to build the K1 noise blanker to take my mind off the KX3!
 
In the errata sheet, I am confused by the change to the bottom of page 5:
'If your board is revision C, solder .........'
 
I have looked at the print on the pcb and it says Rev. Cr
 
Is that revsion C or not I wonder?  I know it's not A or C, but to my mind
Cr does not equal C!
 
Thanks
 
Stephen G4SJP
 
PS.  To UK readers of this, I ordered the kit from QRP project in Germany
and paid less than I would have done direct from Elecraft once the shipping
was taken into consideration.