[Elecraft] K3 High Stability Ref. Oscillator!

[Don Wilhelm]

Jim,

The KTCXO3-1 has always been more stable than its spec'ed 0.5ppm 
stability, so there is no need to calibrate it for temperature vs. 
frequency using software.
Because of that fact, the fields for entering the calibration data have 
been removed from the K3 Utility and also the section referring to 
"Method 3" has been removed from the K3 manual.

In other words, since it is not needed, it has been removed.

73,
Don W3FPR

On 12/16/2011 11:48 AM, Jim Harris wrote:
> *Good morning, All.*
> *
> *
> *I have K3 [S/N2802] with the latest Firmware installed.  I'm also using
> the K3 Utility rev. 1.4.10.11.*
> *
> *
> *When I ordered my kit, I also ordered the KTCX03-1 [0.5ppm] High Stability
> Ref. Oscillator.  When I received this particular kit, with it came a data
> sheet for the KTCXO3-1 with freqs at certain temperatures.  The "then" K3
> Utility revision had a "link" that allowed me to input the data from
> that accompanying sheet into the K3.*
> *
> *
> *Has this "link" been removed?  Why, is it no longer required?  Am I
> missing it within the current K3 Utility?*
>