[Elecraft] KPA-500 - 40 PIN I/O RIBBON CABLE CONNECTOR

[Don Wilhelm]

Manuel,

With ribbon cables, that condition can mean that you have the two ends 
swapped.
It also can mean that you have a cable with the plug in the wrong hole.

73,
Don W3FPR


On 12/3/2011 2:47 PM, manueldeportugal wrote:
> Hello everyone,
> I was just about ready to assemble the front panel, when I realized the
> connector on the 40 pin cable has one position blocked. If one follows the
> assembly manual instructions (the red cable to P1...) you cannot plug in the
> cable because the blockage is on the wrong side.
>
> I would very much appreciate your help.
>
> 73 and thank you
> Manuel
> LU5OM
> CT4IK
> KPA-500 # 562
>