[Elecraft] K3 QRP CW vs SSB default power levels

[Don Wilhelm]

Dennis,

I would suggest two macros - one to switch to CW and set the power to 5 
watts, and the other to switch to SSB and set the power at 10 watts.  
Check out the MD and the PC commands in the K3 Programmer's Reference 
manual.
Use your macros instead of the MODE switch.

73,
Don W3FPR

On 8/30/2011 11:19 PM, Dennis KB7ST wrote:
> Hopefully I am overlooking something simple.  I'm QRP.  When I switch to CW
> MODE, I'd like the K3 to switch power level to 5 watts. On the same band or
> other bands, when  When I switch to SSB MODE, I'd like to the K3 to switch
> to 10 watts.  Instead, I have to adjust the power control each time I switch
> between CW and SSB.  There must be a way to do this without a macro or
> perhaps not?
> Dennis KB7ST
>
>