[Elecraft] [Elecraft_K3] Notch control

[Dick Roth]

I believe that this procedure will adjust notch center frequency rather
than bandwidth.

-- 
73 de Dick, ka1oz
Elecraft K3/100
GAP Titan-DX Antenna



On Tue, 2011-08-30 at 04:58 -0700, Steve WU9B wrote:
> Try holding (instead of tapping) the notch button. Then adjust BW with the 2nd VFO knob.
> 
> 73, Steve WU9B
> 
> On Aug 29, 2011, at 5:59 PM, kk6ue wrote:
> 
> > Hi ALL;
> > A question: I looked through the documentation and did not see any way to adjust the notch bandwidth. If I am running JT65 and I and I wanted to notch out one specific signal, I can do it almost....but not quit all of it. I can use the shift and width to control the entire band pass just wanted a little finer control while still copying all the other signals.
> > Thanks
> > Bob Paull
> > KK6UE
> > 
> > 
> 
> 
> 
> ------------------------------------
> 
> Yahoo! Groups Links
> 
> <*> To visit your group on the web, go to:
>     http://groups.yahoo.com/group/Elecraft_K3/
> 
> <*> Your email settings:
>     Individual Email | Traditional
> 
> <*> To change settings online go to:
>     http://groups.yahoo.com/group/Elecraft_K3/join
>     (Yahoo! ID required)
> 
> <*> To change settings via email:
>     Elecraft_K3-digest at yahoogroups.com 
>     Elecraft_K3-fullfeatured at yahoogroups.com
> 
> <*> To unsubscribe from this group, send an email to:
>     Elecraft_K3-unsubscribe at yahoogroups.com
> 
> <*> Your use of Yahoo! Groups is subject to:
>     http://docs.yahoo.com/info/terms/
>