[Elecraft] Daisy Chain

[Ron D'Eau Claire]

Under FIRMWARE UPDATES in the Owner's manual the text says " Connect your
KPA500 RS232(PC) port to your computer and launch the KPA Utility program."

Ron AC7AC

-----Original Message-----
Connecting the PC to the P3 and then the P3 to the K3 was recently 
discussed.  When I look at the manual for the KPA 500 it shows the PC 
connected to the KPA 500 but only the AUX to the K3 even though there 
is a RS 232 connector marked (XCVR).

So, can one chain the PC through the KPA 500 to the K3 the came way 
as with the P3 and K3? Can you chain all three together?  if so in 
what order?  If one has a KPA 500 and K3 it would be nice not to have 
to swap cables for doing updates etc.

This does not seem to be covered in the KPA 500 manual but somehow 
seems to be implied by the conductor labeling.  It only mentions 
connecting the (XCVR) connector to a Kenwood tranceiver.

David K0LUM