[Elecraft] FW: P3 Manual Calibration procedure question

[Tommy Alderman]

Thanks! I have received a technical response to my question.

Tom - W4BQF


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Tommy Alderman
Sent: Wednesday, August 17, 2011 5:30 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] P3 Manual Calibration procedure question

I'm sure this has been discussed before but if so, I have missed it.

On page 24 of the P3 Owner's Manual, Rev. B, March 29, 2011, under the
heading of Amplitude Calibration the forth button down, it states to set the
signal generator for 7040  kHz and the following button below says to set
the transceiver to approximately 7015 kHz so the signal is centered on the
right half of the display. Is this a typo? If not, can someone please
explain the purpose of doing this?

Thanks and 73

Tom - W4BQF


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html