[Elecraft] P3 Manual Calibration procedure question

[n5ge at n5ge.com]

Tom,

The instructions are correct.

73,
Tom
Amateur Radio Operator N5GE
ARRL Lifetime Member
QCWA Lifetime Member


On Wed, 17 Aug 2011 17:30:10 -0400, "Tommy Alderman" <aldermant at windstream.net>
wrote:

>I'm sure this has been discussed before but if so, I have missed it.
>
>On page 24 of the P3 Owner's Manual, Rev. B, March 29, 2011, under the
>heading of Amplitude Calibration the forth button down, it states to set the
>signal generator for 7040  kHz and the following button below says to set
>the transceiver to approximately 7015 kHz so the signal is centered on the
>right half of the display. Is this a typo? If not, can someone please
>explain the purpose of doing this?
>
>Thanks and 73
>
>Tom - W4BQF
>
[snip]