[Elecraft] KPA500 cables needed
Phil & Debbie Salas
dpsalas at tx.rr.com
Wed Aug 10 09:00:09 EDT 2011
I did get the tip and ring reversed. I.e. TIP is ALC and RING is Tx Req.
However, the Tx Req IS an INPUT to the radio. From the manual:
"This 3.5-mm 3-pin jack accepts external ALC (Automatic
Level Control) voltage from a linear amplifier on the tip
connection, and accepts a "Transmit Request" command
on the ring connection. The main shaft is the ground return.
The "TX Request" connection, when shorted to ground,
puts the FT-897D into the transmit mode, and sends out
a steady CW carrier, for linear amplifier or manual antenna
tuner adjustment."
Phil - AD5X
----- Original Message -----
From: "Joe Subich, W4TV" <lists at subich.com>
To: "Phil & Debbie Salas" <dpsalas at tx.rr.com>
Cc: <elecraft at mailman.qth.net>
Sent: Wednesday, August 10, 2011 7:42 AM
Subject: Re: [Elecraft] KPA500 cables needed
>
>> That ACC jack tip is for an INPUT to the FT-857/897. I.e., grounding
>> this input puts the radio into a CW transmit mode for tuning an
>> external tuner.
>
> Not according to the FT-897 Operating Manual, page 18 (Rear Panel
> Connections). This may be yet another case of blatantly incorrect
> data in Yaesu's manuals but I referred directly to the manual before
> posting the information.
>
> 73,
>
> ... Joe, W4TV
>
> On 8/10/2011 7:04 AM, Phil & Debbie Salas wrote:
>> "The FT-897 has an "extra" TX GND signal on the tip of the ACC jack.
>> A cable with stereo 3.5mm plug to RCA plug can be used to connect
>> the ACC jack to the KPA PA Key jack ... an off the shelf 3.5mm stereo
>> to 2 x RCA cable can be used for ALC and PA Key if desired."
>>
>> That ACC jack tip is for an INPUT to the FT-857/897. I.e., grounding
>> this
>> input puts the radio into a CW transmit mode for tuning an external
>> tuner.
>> The ring is ALC. You must use the miniDIN8 connector for amp keying.
>>
>> Phil - AD5X
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
More information about the Elecraft
mailing list