[Elecraft] KPA500 10 meter behavior

[Don Wilhelm]

Wayne's post yesterday (copied below) had the information to cure it. 
Give that a try.

73,
Don W3FPR
----------------------------------------------------------------------------------------

Bob,

This can usually be corrected (at the K3) by re-doing the power
calibration steps, or by manually setting CONFIG:TXGN HP to a somewhat
lower value. This adjusts the open-loop gain on a per-band basis, and
should correct the overshoot. To change the TXGN HP value you have to
first set CONFIG:TX ALC to OFF. Further details in the K3 owner's
manual. If this doesn't do it, please contact K3 support.

73,
Wayne
N6KR
------------------------------------------------------------------

On 8/9/2011 5:58 AM, n6ax at speakeasy.net wrote:
> Mine does this on several bands......
>
>
>